AT&T 2400 - Manual (Page 108)

9-4 Issue 2 December 1995
Acceptance Tests
Task 3: Forward Subscribers for All Calls
Use this feature to forward all calls to the INTUITY System. The switch
automatically transfers the call to the UCD group administered for the INTUITY
System.
NOTE :
The subscriber’s service feature class must contain call forward RNA
SFI=7. Dterm sets may have a function key for forward on busy (FKY=2).
Use the following instructions to forward all calls for acceptance tests.
1. Using the phone of the first test subscriber, lift the handset and listen for
the dial tone.
2. Dial the access code or press the function key for forward all calls.
After you perform the action you hear a second dial tone.
NOTE :
If you do not know the access code or the function key for forward
all calls, contact your switch administrator. The switch administrator
sets the codes and function keys during the initial setup of the
switch.
3. Dial the main extension of the UCD group to forward all calls to integrated
voice mail. You created the UCD main extension during the switch
administration process in Chapter 7 of this document.
Repeat Task 1, 2, and 3 for the second test subscriber. After you administer all
features for both test subscribers, return to the “Acceptance Test” chapter in
INTUITY Software Installation, 585-310-140, and complete the acceptance test
procedures.