AT&T 2400 - Manual (Page 75)

Issue 2 December 1995 7-5
Administer Analog Voice Mail Ports
9. In the RSC (Route Restriction Class) field, you see a default value of 0.
Enter the correct RSC. After you press the cursor moves to the SFC
field.
Contact your switch system administrator to determine if the default value
is correct.
10. In the SFC (Service Feature Class) field, you see a default value of 0. Enter
the correct SFC.
Contact your switch system administrator for the correct SFC value.
11. When you finish editing the final field, press to confirm the station
administration.
12. When you assign the first station data command for a Line Package, the
message PKG CHECK appears on the screen.
Check that the correct circuit card is in the correct slot and press .
After you press the cursor returns to the first field.
If you continue to assign station data commands to the same Line
Package, you receive a
WRT? message after entering the station
information.
Enter Y to confirm the information. After you press the cursor
returns to the first field.
13. Repeat steps 5 through 12 for each analog voice mail port you need to
assign. For example, if you have already assigned extension 500 but you
still need to assign extensions 501, 502, and 503, return to Step 5 and
enter 501 as the second extension. Repeat the process until 502 and 503
have been assigned. When you finish entering the analog voice mail port
numbers, press
to return to the Station Data Commands menu.
Proceed to the next section, “Assign Voice Mail Extensions to a UCD
Group.”
ENTER
ENTER
ENTER
ENTER
ENTER
/