AT&T 2400 - Manual (Page 95)

Issue 2 December 1995 8-7
Saving and Starting the Configuration
Saving and Starting the Configuration
After you administer the basic parameters and assign extensions and LTNs, you
must save the configuration. You also can start the integration at this point,
although you should perform the tasks in the “Administer Serial Data Links”
section to check the default settings for the MCI and SMDI communication links.
Use the following instructions to save the configuration and start the system.
1. Press on the SID keypad.
After you press the key, you see the SETUP menu.
2. Press again to return to the MAIN MENU.
After you press the key and return to the MAIN MENU, the SID checks the
current configuration against the information you entered. Because you
made changes to the configuration, the SID places the following prompt
on the screen:
3. Press to select Yes and save your configuration changes.
After you press the key, the SID saves the information you entered and
shows the following message on the screen:
4. After a short pause, the SID places another prompt on the screen as
shown below:
5. If you want to start the integration, press to select Yes.
If you are not ready to start the integration, press to select NO.
After you press you see the Restarting System... message on the screen. The
SID pauses for a few seconds then starts the integration. When the integration
SAVE EDITS? 1-Yes 2-No
Setup Saved...
START SYSTEM? 1-Yes 2-No
FUNC
FUNC
1
1
2
1