AT&T 2400 - Manual (Page 85)

Issue 2 December 1995 7-15
Configuring the Message Center Interface Link
Define the Port as a Terminal
You must now designate that the port assigned to the MCI link is a terminal or
two-way communication port. If you do not perform this step, the switch uses the
port as a printer or one-way communication port.
Use the following instructions to define the MCI port type.
1. At the Installation Commands menu, shown in Figure 7-6., enter 1 to select
the System Data option. After you press , you see the Assignment of
Station Data screen as shown in Figure 7-9.
Figure 7-9. Assignment of System Data
2. Enter 1 in the SYS field to tell the switch that the parameter changes effect
the entire system.
3. Enter the index number in the INDEX field that corresponds to the port
number you entered in the previous section, "Assign a Port for the
Message Center Interface Link". Use Table 7-2 to determine the index
number for the port.
ENTER
Assignment of System Data
SYS: 1 SYS : System Data Items
INDEX: 117 DATA: 01 1-System Data 1
2-System Data 2
3-System Data 3
TN : Tenant Number
INDEX: System Data Index
System Index
1 0-255
2 0-15
3 0-31
DATA : System Data (Hexa-decimal)