AT&T System 25 - Manual (Page 35)

INSTALLATION
Cables
Splitter Cables
The splitter cables (Figure 2-5) connect trunk circuits from the 700A jacks to the
system cabinets or 10B ETU (3:1 only).
3:1 Splitter Cable (WP90929, L1)
This cable connects the twenty-four 1-pair trunk circuits on a 700A jack to three
8-port trunk circuit packs (loop start, ground start, or DID). The connection may
be either director through a
are male.
2:1 Splitter Cable (WP90929, L3)
10B ETU. Al 25-pair ribbon connectors on the cable
This cable connects eight 3-pair tie trunk circuits
trunk circuit packs. All 25-pair connectors on the
on a 700A jack to two 4-port tie
cable are male.
3:1 SPLITTER CABLE
W P 9 0 9 2 9 , L 1
2:1 SPLITTER CABLE
WP90929,L3
Figure 2-5. Splitter Cables