Main menu, 1 autosetup, Autosetup – Barco R9003110 User Manual
Page 49
7. Main Menu
7. MAIN MENU
7.1 Autosetup
Introduction to Autosetup
Autosetup creates the best suited image file for the connected source.
Therefore Autosetup calculates/measures several parameters of the sources:
•
Total pixels per line
•
Start pixel
•
Phase
•
Contrast/Brightness levels
The measure of the total number of pixels per line can be done through 2 methods
•
Limited scan: a windowing is used to allow fast tracking, takes about ...
•
Full scan: tracking is done over the full range, takes about ...
How to setup the scan method ?
1. Press MENU to activate the Toolbar
2. Press → to select the Main item
3. Press ↓ to Pull down the Main menu
4. Use ↑ or ↓ to select Autosetup
5. Press → to pull down the menu (image 7-1)
6. Use ↓ or ↑ to select the desired method
7. Press ENTER
Image 7-1
R5976741 MGP 15 MEDICAL GRADE PROJECTOR 28/04/2004
45