Barco R9003110 - Manual (Page 99)

11. Tools
The logo display is only possible in the full screen mode, a logo can thus not be displayed (rescaled) in a
window in the PiP mode.
When there is no signal connected, the projector will also start its standby timer countdown (if enabled) and
shuts down after the predetermined time.
11.9 Logo
What can be done ?
A screenshot can be taken from an active projected image. This screenshot is then saved and can be used as background.
Each new screenshot erases the previous logo, therefore a warning message is displayed asking the user to confirm.
How to take a screenshot ?
1. Press MENU to activate the Toolbar
2. Press → to select theTools item
3. Press ↓ to Pull down the menu
4. Use ↑ or ↓ to select Logo
5. Press → to open the menu
6. Use ↑ or ↓ to select Take screenshot (image 11-23)
7. Press ENTER
A dialogbox is displayed. Press yes to confirm. (image 11-24)
A textbox shows the evolution of the operation. (image 11-25, image 11-26)
Image 11-23
Image 11-24 Image 11-25
Image 11-26
R5976741 MGP 15 MEDICAL GRADE PROJECTOR 28/04/2004 95