6 lamp mode selection, Lamp mode selection – Barco R9003110 User Manual
Page 78
10. Settings
10.6 Lamp mode selection
What are the different lamp modes ?
Single mode
The projector will always switch to the lamp with the shortest runtime when the difference between the runtimes of lamp1 and lamp
2 reaches 100 hours, switching from one lamp to another happens only at switching on of the projector and not during operation.
When the lamp fails or reaches its maximum runtime the projector switches automatically to the other lamp without interrupting the
projection.The failure is logged and the lamp will never be initialized in the future.
Image 10-16
Single mode operation: switching principle
Dual mode
Both lamps are working.
When one lamp fails, the projector continues the projection using the remaining lamp.
How to select the lamp mode ?
1. Press MENU to activate the Toolbar
2. Press → to select the Settings item
3. Press ↓ to Pull down the menu
4. Use ↑ or ↓ to select Lamp
5. Press → to pull down the menu
6. Use ↑ or ↓ to select the mode (image 10-17)
7. Press ENTER
A bullet shows the active mode.
74
R5976741 MGP 15 MEDICAL GRADE PROJECTOR 28/04/2004