Barco R9003110 - Manual (Page 75)

10. Settings
10.3 Restoring the factory settings
How to restore the factory settings for the display function and the color temperature ?
1. Press MENU to activate the Toolbar
2. Press → to select the Settings item
3. Press ↓ to Pull down the Settings menu
4. Use ↑ or ↓ to select Factory reset (image 10-7)
5. Press ENTER
The display function and color temperature are adapted and the corresponding LUT is loaded.
Image 10-7
Factory settings are “dark room” settings meaning they do not take account of environmental conditions (am-
bient light, glare,...).
10.4 Black and white selection
Build up of the Luminance signal Y
The color signals on the 5 BNC connectors can be chosen to be converted to a luminance signal Y in several ways. The contribution
to the luminance signal can be chosen to be done by one or more color components.
Additionally, switching color components may accentuate some details and that way emphasize a part of the projected image.
Selection Projected image Comment Image
RGB to RGB color - image 10-8
G to Y black & white Green is replaced by white (bright) image 10-11
RGB to Y black & white - image 10-9
R to Y black & white Red is replaced by white (bright) image 10-10
B to Y black & white Blue is replaced by white (bright) image 10-12
RBG to Y black & white bars are repositioned image 10-13
GRB to Y black & white bars are repositioned -
GBR to Y black & white bars are repositioned -
BRG to Y black & white bars are repositioned -
BGR to Y black & white bars are repositioned -
R5976741 MGP 15 MEDICAL GRADE PROJECTOR 28/04/2004 71