Brother MFC 7550MC - Manual (Page 120)

REMOTE FAX OPTIONS
8 - 9
MFC 4550/6550MC/7550MC
OP-US-5.0
If you hear one long beep, the change is accepted. If you hear
three short beeps, you can not change it because the conditions
(ex. registering fax forwarding or paging number) have not been
completed. You can register your fax forwarding number by
using 4. FAX FWD No. (see page 8-10). Once you have registered
the number, the machine automatically will turn to “FAX
FWD:ON” mode. To receive a Memory Status List, enter 961 (see
page 8-10). Check the List to make sure the Fax Forwarding
number you registered is correct. Then enter the confirmation
command 955. Now the machine will start Fax Forwarding.
You can set FAX STORAGE ON or OFF.
You must call from a remote fax machine to receive the Memory
Status List or stored fax message(s). (See page 8-10.)
If you hear one long beep, you can erase fax message(s) from the
memory.
You can check whether your MFC has received any fax message(s).
If yes, you will hear one long beep. If no, you will hear three short
beeps.
If you hear one long beep, you can change the Answer Mode. If
you hear three short beeps, you can not change it.
After a long beep, you can exit remote control.
Remote Control Commands
You can control your MFC with the following remote control commands.
Remote control command Detail Operation
95 Changing Fax Forwarding
/Paging
setting
1 O F F
2 Fax Forwarding
3 Paging
4 FAX FWD No.
5 FWD No. Confirm
6 Fax Storage ON
7 Fax Storage OFF
96 Retrieve FAX
1 Memory Status List
2 00 Retrieve all FAXES
2 “MSG No.” 00
Retrieve by MSG
number
3 Erase FAX in the
memory
97 Check the receiving status
1 F A X
98 Change Answer Mode
1 T A D
2 F/T
3 Fax
90 Exit