Brother MFC 7550MC - Manual (Page 177)

HOW TO USE THE COPY FUNCTION
12-1
MFC 4550/6550MC/7550MC
OP-US-5.0
Copy
12. HOW TO USE THE COPY FUNCTION
Use the Copy key to make a single copy or multiple copies. When making copies,
check that the text or image on the original document is not too close to the edge. Your
MFC can not read anything closer than 4 mm (1/8 inch) from the edge. Original
documents should be straight and not wrinkled or they may jam. Also, do not pull on
the paper while copying is in progress or you may distort the image and damage your
MFC.
Make sure there is enough recording paper in the MFC. And when making multiple
copies, do not let the paper tray become overstacked. Remove copies from the paper
tray.
(For MFC 4550)
Set the resolution to either PHOTO, FINE or S.FINE. If you select STANDARD, the
resolution will change automatically to S.FINE. However, when you make a single
copy and select S.FINE, the resolution may change automatically to FINE in case
memory is used for memory transmission.
Making a Single Copy
KEYS TO PRESS
1. Insert the documents face down into the
feeder.
2. Press Copy .
0 9 / 1 2 / 1 9 9 6 1 5 : 2 5
O N L I N E
FAX: NO. & START
SCAN READY
N O . O F C O P I E S : 0 1
O N L I N E
THE DISPLAY WILL SHOW:
COPY: PRESS COPY
SCAN READY
ENTER & COPY KEY
O N L I N E
C O P Y I N G
O N L I N E
COPYING P.01
O N L I N E
COPYING P.02
O N L I N E
3. Press Copy or just wait for 5 seconds