Sharp R82STMA - Manual (Page 23)

21
OTHER CONVENIENT FUNCTIONS
2. TIMER:
You can use the TIMER for timing where microwave cooking is not involved. For example, to time boiled
eggs cooked on a conventional hob, to monitor the standing time for microwaved food or to remind you
of the time when making a phone call.
3. When the water comes to
the boil, add the egg, and
press the START/AUTO
MINUTE key once.
2. Press the 1 MINUTE
key 5 times.
1. Press the
TIMER
key once.
Example: To set the timer for 5 minutes to boil an egg on a conventional hob.
A sequence of 4 stages (maximum) can be programmed using combinations of MICROWAVE,
CONVECTION, GRILL or DUAL COOKING.
1st Stage 2nd Stage
Example:
If you want to cook for 5 minutes on 100% microwave power and then for 16 minutes on 30% power.
Input the time
(5 min.)
Input the
power 100%
(HIGH)
Input the time
(16 min.)
Input the
power 30%
(MED LOW)
Start
x5 x1
• To programme a series of sequences: Input the cooking time followed by the desired cooking mode.
• Repeat this procedure three times, to a maximum of four sequences.
• Finally, press the START/AUTO MINUTE key to start sequence cooking.
You can enter any time up to 99 minutes, 90 seconds. To cancel the TIMER whilst counting down, simply
press STOP/CLEAR and the display will return to the time of day, if set.
4. The display will count down.
When the display reaches
zero, the ‘beep’ signal will
sound.
1. MULTIPLE SEQUENCE COOKING:
x1
To check the microwave power level during cooking press the MICROWAVE POWER LEVEL key. As long as
your finger is touching the MICROWAVE POWER LEVEL key the power level will be displayed.The oven
continues to count down although the display will show the power level.
3. TO CHECK THE POWER LEVEL
R- 82STM Op Man/Ck Bk 04/07/2000 12:25 Page 21