B&B Electronics Network Device I-7011 - Manual (Page 34)

34
I-7011, I-7018 User Manual Rev:B1.0
2.13 $AA8V
Description : Set LED Configuration
Syntax : $AA8V[CHK](cr)
$ delimiter character
AA address of setting module (00 to FF)
8 command for setting LED configuration
V 1=Set LED to module, 2=Set LED to host
Response : Valid Command : !AA[CHK](cr)
Invalid Command : ?AA[CHK](cr)
Syntax error or communication error may get no re-
sponse.
! delimiter for valid command
? delimiter for invalid command
AA address of response module(00 to FF)
Example :
Command : $0182 Receive : !01
Set address 01 LED to host control, return success.
Command : $0281 Receive : !02
Set address 02 LED to module control, return success.
Related Command :
Sec2.12 $AA8, Sec2.18 $AAZ(Data)
Note : The command is for I-7011D/11PD only