Brocade Communications Systems Brocade MLX Series and Brocade Netlron XMR 53-1002373-02 - Manual (Page 209)

Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide 191
53-1002373-02
Installing a Brocade MLX-32 router
3
• Brocade MLX-32 router chassis with the empty slots covered with upper and lower shipping
panels. The router is housed in a wooden shipping crate that is strapped to a pallet.
• The appropriate number of interface modules, switch fabric modules, management modules,
and power supplies in separate shipping cartons.
• 32 slot blanks in separate shipping carton.
• Insertion or extraction tool for use with RJ45 and fiber-optic connectors.
If any of these items are missing, contact the place of purchase.
Removing the Brocade MLX-32 router from the shipping crate
The Brocade MLX-32 router ships in a wooden crate that is bolted to a wooden platform that rests
on a pallet.You will need the following tools to remove the router from the shipping crate:
• A forklift or pallet jack with a minimum limit of 550 lbs to move the router crate on the pallet.
• A mechanical lift with a minimum 350 lb limit to move the router off the pallet. The ideal lift
configuration is a counterweight base material lift with a metal lift plate installed in place of
the forks. The metal plate should be no wider than 17 inches, so that it will fit between the rack
mount rails.
• A strap to stabilize the router while you are moving it on the mechanical lift.
• A power drill with the following attachments:
- Large Phillips screwdriver
- Large flat-blade screwdriver
- 7/16-inch socket wrench
1. The router shipping crate must be in the upright position with enough space to slide the crate
off of the pallet.
2. Use a power drill with Phillips and large flat-blade screwdriver attachments to remove the bolts
and screws that hold the front shipping crate panel in place, as shown in Figure 135 . Remove
the front panel and set it aside.