Replacing the air filters, Figure 237, Figure 238 – Brocade Communications Systems Brocade MLX Series and Brocade Netlron XMR 53-1002373-02 User Manual
Page 385: Pulling
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide
367
53-1002373-02
Replacing fan assemblies
8
FIGURE 237
Replacing the fan assembly in a Brocade MLXe 4-slot router
FIGURE 238
Replacing the fan assembly in a Brocade MLXe 8-slot router
3. Insert the new fan assembly into the fan slot and push the enclosure in until the faceplate is
flush with the router. Pushing the enclosure in seats the fan connector with the router
connector.
4. Tighten the four captive screws to secure the fan to the router.
5. Access the CLI, and enter the show chassis command to verify that the fans are operating
normally.
Replacing the air filters
It is strongly recommended that routers be installed in environments that have minimal dust and
airborne contaminants. If routers are installed in environments where dust or other airborne
contaminants may be present, air filters should be inspected and replaced as needed. Maintaining
clean air filters ensures optimal airflow through the devices.