IKA ULTRA-TURRAX Tube Drive control - Manual (Page 16)

16
UTTD_c_022014
Contents
EN
EC-Declaration of conformity
We declare under our sole responsibility that this product
corrosponds to the regulations 89/336EC, 98/37EC and 2006/95EC
and conforms with the standards or standardized documents DIN
EN IEC 61010-1, DIN EN IEC 61326-1, DIN EN ISO 12100-1, -2 and
EN 60204-1.
Explanation of symbols
General hazard
This symbol identifies information that is of vital
importance for safeguarding your health
and safety. Disregarding this information can
lead to health impairment and injuries.
This symbol identifies information that is of
importance for the technically correct
functioning of the system. Disregarding this
information can result in damage to the instru-
ment or to system components.
This symbol indicates information which is im-
portant for ensuring that the operations of
the appliance are performed efficiently and
for using the instrument. Failure to observe
this information can result in inaccurate results.
Risk of biohazard infection.
Risk of hand injury.
WARNING
ATTENTION
DANGER
DANGER
DANGER
Seite
1 EC-declaration of conformity 16
2 Explication of warning symbols
16
3 Safety instructions 17
4 Unpacking
18
5 Correct use 18
6 Useful facts 19
7 Interfaces and outputs 19
8 Commissioning 20
9 Switching on 20
10 Factory setting 21
10.1 Resetting parameters to factory setting (RESET) 21
11 Set menu parameters 22
11.1 Operation mode 22
11.2 Operation language 22
11.3 Maximum rotation speed (max rpm) 23
11.4 Maximum timer value (timer max) 23
12 Set working parameters 24
12.1 Target speed (target rpm) 24
12.2 Timer value (timer sec) 24
12.3 Reverse function (rev sec) 24
12.4 Turbo function 24
13 Error message 25
14 Maintenance
25
15 Accessories 26
16 Warranty 26
17 Technical data 27
Source language: German