JLG X17J Plus Operator Manual - Manual (Page 14)

CONTROL POSITION ON THE GROUND:
There is a second control position available for the tracked part of the machine. This is not in
a fixed position but rather can be located on the ground within a radius of 2.5 m from the
basket attachment. To control the machine from this position, the operator uses the same
remote control, removing it from its housing in the basket and using the cable provided.
From this control position, the operator IS NOT enabled to control the aerial
part of the machine, but only the tracks, stabilisers and track extension func‑
tion.
DANGER! when controlling the machine from the ground position, keep a
distance of at least 1 m from the tracks.
DANGER! when controlling the machine from the ground position, always
make sure that the component that is being moved is completely visible and
constantly check its trajectory.
‑ EMERGENCY CONTROL POSITION
There is a control position which will be identified as the emergency control position. This is
located on the ground part of the machine, next to the distributor for the aerial part. To ena‑
ble it, press the special selector positioned on the base of the turret (see photo) until the green
warning light comes on. The light indicates that the movements of the aerial part are ena‑
bled.
From this position, the movements of the machine can be controlled directly using the levers
on the various hydraulic distributors, aerial part (see photo 1) and proportional (aerial part,
see photo 2).
The emergency control position was designed to operate on the extensible structure only
for emergency operations by emergency service personnel on the ground, who must in
any case be trained and know the operation of the machine and its safety devices, as well
as for maintenance and checks before starting work.
X17JPR0020413 10
BOOM LIFT MODELS X17JPLUS
JLG
ATTENZIONE
DANGER
THERMIC MOTOR LITHIUM MOTOR