JLG X17J Plus Operator Manual - Manual (Page 23)

USE THE TYPE‑APPROVED AND CERTIFIED SAFETY HARNESSES. BEFORE
WORKING AT A HEIGHT, MAKE SURE THAT THE SAFETY HARNESSES ARE COR‑
RECTLY FASTENED AND CONNECTED TO THE ANCHORAGE POINTS ON THE
BASKET.
T
HE USE OF HARNESSES IS COMPULSORY IN ACCORDANCE WITH LOCAL LEGISLATION IN EACH INDI ‑
VIDUAL COUNTRY
. I
N COUNTRIES WHERE THE LAW DOES NOT REQUIRE THE USE OF SUCH SAFETY
SYSTEMS , THE EMPLOYER AND / OR USER IS RESPONSIBLE FOR CHOOSING THE SYSTEM TO BE USED .
Safety valves and electrical system safety components
It is prohibited to modify and/or tamper with the safety and control valves of the main
hydraulic system and the adjustments of the electric plant. The Constructor is not liable
for injury to persons and damage to objects or to the machine if the standard calibration
of any hydraulic and electric/electronic component is tampered with.
Fire prevention
Keep the area around the motor clean, removing fragments of
wood, paper and other flammable products; clean any fuel
leaks as these may be a potential cause of fire.
Petrol is extremely flammable and explosive in particular con‑
ditions. Refuel in well ventilated areas and with the engine at
rest.
Avoid smoking and producing sparks in the refuelling and
fuel storage area.
After refuelling, make sure to put back the cap correctly. Take care to avoid touching the
exhaust silencer when this is hot, i.e. with the machine running or soon after stopping the
engine.
Preventing damage caused by washing the machine
Do not direct high pressure jets towards the electrical compo‑
nents while washing the machine. Do not use chemical deter‑
gents or petrol that would damage the plastic parts and the
painting.
BEFORE WASHING THE MACHINE, ALWAYS REMEMBER TO REMOVE THE REMO‑
TE CONTROL AND CORRECTLY CLOSE THE REMOTE CONTROL AND EQUIP‑
MENT CONNECTION SOCKETS LOCATED ON THE MACHINE.
X17JPR0020413
BOOM LIFT MODELS X17JPLUS
JLG
19
IMPORTANTE
WARNING