JLG X17J Plus Operator Manual User Manual
Page 70
6.2 PROCEDURES FOR CORRECT USE
Below find the procedures for use of the platform as declared by the Constructor. Any use
different to that stated below, unless authorised in writing by the Constructor. is prohibited.
6.2.1 SUMMARY TABLE OF OPERATOR SAFETY STANDARDS
The summary table shown below lists the general safety standards that must be followed
scrupulously by the operator before using the platform.
Remember that a sticker with this table can be found near the controls positioned on the
basket, where it is well visible from the control position.
•
The elevating platform can only be used by specialised, previously‑trained personnel.
• All operations of the extensible structures must be performed from the control position in
the basket. The travel and stabilisation operations must be carried out after checking that
there is complete visibility of the work area. Before starting operation, examine the work
area, taking note of overhead power lines, moving machinery, such as overhead cranes and
road, rail and building equipment.
• The instructions contained in the USER AND OPERATION MANUAL that is provided
together with the machine must be followed scrupulously.
•
Do not exceed the maximum allowed capacity indicated in the USER AND OPERATION
MANUAL and on the basket.
•
The operator must wear a hard hat and a safety harness appropriately attached to the rele‑
vant anchorage points on the basket.
Remember that the safety harnesses must be checked periodically.
The use of harnesses is compulsory in accordance with local legislation in each individual
country. In countries where the law does not require the use of such safety systems, the
employer and/or user is responsible for choosing the system to be used.
•
Before starting work, the operator must make sure that all the safety devices are in good
working order, and check the efficiency of the main mechanical parts as well as the fuel and
hydraulic oil level.
Never operate on soft, rough, slimy ground or on slopes that exceed the allowable gradient,
in order to ensure that the platform is completely stable.
Make sure that the stabilisers rest on stable HORIZONTAL surfaces.
•
Level the machine’s chassis perfectly respecting the maximum allowable gradient indicated
in the USER AND OPERATION MANUAL and visible on the spirit level.
•
Before performing any movement, check that there are no obstacles in the work area and
that no people are in the trajectory.
•
It is prohibited to carry out work at a distance of less than 5 metres from power lines and
electrical equipment.
•
It is prohibited to operate in unfavourable atmospheric conditions.
•
It is prohibited to anchor cables, ropes or the like to the platform and to use the platform as a
lifting device.
•
It is prohibited to secure ladders, stools or the like to the platform basket to increase the
X17JPR0020413
66
BOOM LIFT MODELS X17JPLUS
JLG