JLG X17J Plus Operator Manual - Manual (Page 87)

bubble it contains is completely inside the green area (see photo below) the machine is in
conditions that allow operation.
Please note that stabilize the machine on slopes greater than allowable limits (see technical
data of the machine) does not permit correct stabilization and is a serious danger for users.
On each stabiliser (see photo below), near the cylinder coupling, there is an orange light.
This light flashes to indicate that the stabiliser is resting on the ground.
Note: IT IS IMPORTANT TO REMIND THAT WHEN THE STABILISERS ARE LOWE‑
RED THE CARRIAGE MUST ALWAYS BE RAISED FROM THE GROUND.
AFTER USING THE MANUAL STABILISER CONTROL, REMEMBER TO PRESSURISE
THE BOTTOM OF THE STABILISER CYLINDERS. TO DO THIS, RUN AN AUTO‑STA‑
BILISATION CYCLE OR LOWER EACH STABILISER FOR ONE SECOND.
An electronic spirit level on the electronic control board checks that the machine is effectively
level within the allowable tolerance and enables the movements of the aerial part.
Incorrect machine stabilisation does not ensure suitable stability to perform operations. The
Constructor prohibits the use of the machine if it is not stabilised as described in this manual;
the machine overturning may cause serious injury to or even death of its occupants and per‑
sonnel on the ground.
If one of the orange lights positioned on each stabiliser should flash even when the stabi‑
liser is lifted from the ground, stop the machine immediately and call the after‑sales servi‑
ce as this signals the breakage of the corresponding stabiliser microswitch.
X17JPR0020413
BOOM LIFT MODELS X17JPLUS
JLG
83
IMPORTANTE
WARNING