JLG X17J Plus Operator Manual User Manual
Page 80
T
RAVEL PROCEDURE
Before travelling, proceed as follows:
‑
Check that all instructions previously given in this chapter have been complied with;
‑
Make sure that the ground is compact and can support the weight of the machine;
‑
Check that there are no obstacles in the travel area, considering the overall dimensions
of the machine;
‑
The machine is completely closed and aligned, in the transport or stabilisation position
or with the jib arm partially or totally lifted in the transport or stabilisation position.
This configuration is ONLY ALLOWED WHEN STRICTLY NECESSARY.
‑
Select the travel speed according to the need and as described above, operating the rele‑
vant button and checking the selection on display;
‑
Operate joysticks 1 and 8 to move the tracks;
If the operator attempts to travel with one or more stabilisers on the ground, an error
message will appear on the display warning the user to raise the stabilisers in order to
allow the machine to travel.
T
RAVELLING ON SLOPES
The maximum slope for travel is shown in the
machine specifications at the beginning of this
manual.
When travelling on inclined surfaces, lower the
stabilisers on the downward side for further
safety in the event of sudden changes in slope.
X17JPR0020413
76
BOOM LIFT MODELS X17JPLUS
JLG