JLG X17J Plus Operator Manual - Manual (Page 49)

4.1.1 DISPLAY
The display is used to view the status of the machine and the operating information neces‑
sary or useful for the operator.
When the machine’s main control board is powered via the engine key, the information to be
shown on the display is sent to the remote control.
This operation has a variable duration. Normally a few seconds are sufficient, however the
following screen may appear on the display:
In this case about 5‑10 minutes are needed to send all the information from the main board
to the remote control. The machine cannot work during this period.
Do not stop the machine or operate it during this period.
4.1.1.1 DISPLAY MAIN SCREEN
When the machine is started, the main screen is displayed, giving a general overview of the
machine status. For the sake of simplicity and clarity a layout is provided with 8 icon display
positions.
Example of the main screen: Icon position diagram:
X17JPR0020413
BOOM LIFT MODELS X17JPLUS
JLG
45