JLG X17J Plus Operator Manual - Manual (Page 89)

If the selfstabilization procedure has not been completed and the OK message has not appea‑
red on the display it will not be possible to move the aerial part of the machine and at every
attempt to do it an error message will appear: AUTOSTAB NO. Repeat the Selfstabilization
operation to enable movements.
After the end of the procedure, always control that the spirit level is in the green zone. If this
does not occur contact JLG after sales service.
If during lowering one of the stabilisers does not touch the ground, the machine will conti‑
nue to operate the cylinder at the end of its stroke until the motor switches off or the self‑
levelling procedure ends. This situation is normal and indicates that the slope the machine is
situated on exceeds the allowable limit for stabilisation. If at the end of the stabilisation
phase the machine has to be lifted even further from the ground, a new self‑levelling proce‑
dure can be run.
NOTE: using the self‑levelling procedure does not affect the operation of the stabilisers in
manual mode.
• AUTOMATIC RAISING OF THE STABILISERS
Press and hold button 1 on the remote control.
The four stabilisers will start to lower the machine and then will retract completely.
X17JPR0020413
BOOM LIFT MODELS X17JPLUS
JLG
85
OK