JLG X17J Plus Operator Manual - Manual (Page 45)

3.7 BASKET LOAD SENSOR
The load sensor on the basket is made up of a basket sup‑
port with two shafts that only allow the vertical move‑
ment of the basket. The basket support is supplied by the
load cell itself. Two strain gauges are positioned inside
the sensor positioned under the basket and convert the
relative weight inside the basket into an electrical signal.
The electrical signal is then sent to the electronic board,
which processes it and identifies any dangerous condi‑
tions.
The remote control display always shows the maximum load allowed according to the work
mode.
When the maximum allowable load is reached, an icon appears on the remote control
display, a sound signal is emitted and all platform movements are disabled.
To restore platform operation the excess weight must be removed in order to return below
the maximum allowable weight (see paragraph on the display).
The Constructor recommends that maximum attention is paid to
the conditions of all safety components and in particular of the
system that makes up the basket load sensor; always check cor‑
rect operation whenever objects are struck with the basket or if
performing operations that may damage the system (e.g. pru‑
ning, painting etc.).
Before any elevating manoeuvre, always make sure that the two closing covers on the ver‑
tical pins are completely screwed in.
ATTENZIONE
PERICOLO
COVER
X17JPR0020413
BOOM LIFT MODELS X17JPLUS
JLG
41
DANGER
DANGER