Disassembly, Disassembly -21 – JLG 600SC_660SJC Service Manual User Manual
Page 123
Advertising
SECTION 4 - BOOM & PLATFORM
3121607
– JLG Lift –
4-21
Disassembly
1.
Remove capscrews (113) over end cap lock pins (109).
2.
Using a 1/8” (3.18mm) drill bit, drill a hole in center of
each lock pin approximately 3/16" (4.76mm) deep.
3.
Remove lock pins using an ”Easy Out” (Size #2 shown. If
pin will not come out, use 5/16" drill bit 1/2" (12.7mm)
deep to drill out entire pin.
4.
Remove end cap (4) using tools provided with Helac seal
kit.
5.
Using a metal bar or similar tool, unscrew end cap (4) by
turning it counter clockwise.
6.
Remove end cap (4) and set aside for later inspection.
Advertising