JLG 600SC_660SJC Service Manual - Manual (Page 252)

SECTION 7 - BASIC ELECTRICAL INFORMATION & SCHEMATICS
7-8 – JLG Lift – 3121607
7.5 DEUTSCH CONNECTORS
DT/DTP Series Assembly
1. Grasp crimped contact (1) about 25mm behind contact
barrel.
2. Hold connector with rear grommet (2) facing you.
3. Push contact straight into connector grommet (3) until a
click is felt. A slight tug confirms it is locked in place.
4. Once all contacts are in place, insert wedgelock (4) with
arrow pointing toward exterior locking mechanism. The
wedgelock will snap into place. Rectangular wedges are
not oriented. They may go in either way.
NOTE: Receptacle shown - use same procedure for plug.
Figure 7-20. DT/DTP Contact Installation
DT/DTP Series Disassembly
1. Remove wedgelock (1) using needle-nose pliers or a
hook shaped wire to pull wedge straight out.
2. To remove contacts, gently pull wire backwards at the
same time releasing the locking finger (2) by moving it
away from contact with a screwdriver.
3. Hold rear seal (3) in place. Removing contact may dis-
place seal.
Figure 7-21. DT/DTP Contact Removal
1 2
3 4
1 2
3