Hub - disassembly, Hub - disassembly -20 – JLG 1230ES Service Manual User Manual
Page 56
Advertising
SECTION 4 - BASE COMPONENTS
4-20
– JLG Lift –
3121222
Hub - Disassembly
Hub Disassembly
1. Remove Main Wheel Bearing (14).
NOTE: This part is held in the hub with a press fit. To remove have the hub setting seal side up. Use a plate or rod with a large enough
diameter push in the inner race of the bearing. Apply force to the push the bearing out. This bearing will need to be replaced upon
reassembly.
2. Remove main Lip Seal (16).
NOTE: This Lip Seal (16) is also held in with a press fit. Remove the Lip Seal only if the hub or seal needs to be replaced. The Lip Seal will
most likely become damaged during removal. Try not to damage the hub bore.
Advertising