JLG 1230ES Service Manual User Manual
Page 59
Advertising
SECTION 4 - BASE COMPONENTS
3121222
– JLG Lift –
4-23
11. Press the Output Planet Shaft (10) into the Spindle (1) until it bottoms out. Make sure the Output Planet Gear (9)
turns freely after the Planet Shaft is pressed in.
12. Repeat Steps 5-11 for the other two Output Planet Gears (9).
13. Turn the Spindle (1) over so that the carrier end is down.
14. Using a flat plate or rod, press the Motor Shaft Seal (17) into the center bore so that it is flush with the face of the
Spindle (1).
Advertising