Motor assembly, Motor assembly -28 – JLG 1230ES Service Manual User Manual
Page 64
Advertising
SECTION 4 - BASE COMPONENTS
4-28
– JLG Lift –
3121222
Motor Assembly
Motor Assembly
1. Insert motor (13) into back of the gearbox. Motor will pilot on the 4 bosses in the gearbox. Try to keep the end of
the motor shaft from causing damage to the lip seal in the gearbox.
NOTE: The motor may need to be rotated to line up the sun gear splines with the motor shaft splines.
2. Install the 2 Motor Mounting Bolts (M7) and Washers (M8). Tighten to 9-11 ft-lbs.
3. Connect the end of the power cable to the power controller, route cable per instruction in Figure 4-3.
4. Fill the gearbox with oil, See Oil Type & Capacity on Page 4-12.
Advertising