JLG 1230ES Service Manual - Manual (Page 79)

SECTION 5 - CONTROL COMPONENTS
3121222 – JLG Lift – 5-3
Manual Brake Release Switch AC Power - Breaker Box Installation (CE
Specification Machines ONLY)
The AC power breaker box is wired inline on the power cir-
cuit of the AC receptacle box mounted in the platform.
See illustration below for mounting instructions, for Infor-
mation on the various plugs types and specific wiring for
each plug type see Section 9.12, AC POWER RECEPTA-
CLES AND WIRING (PLATFORM) - CE SPEC MACHINES
ONLY in Section 9 of this manual.
Manual Brake Release Switch - Installation
1. Release Switch
2. Washer 3. Nut
4. Charger/Step Plate Cover
Note: Located on rear of machine, under charger/step plate cover.
AC Power - Breaker Box - Installation
(CE Specification Machines ONLY)
1. Cover Plate Mounting Screws
2. Cover Plate
3. Breaker Assembly
4. Mounting Screw Plugs 5. Box to Frame Mounting Screws
6. Breaker Box Base
7. Breaker Box Shield
8. Box to Frame Mounting Screw - Nuts and Washers
Note: Located on left rear of machine, just above the machine nameplate.
2
3
4
5
6
1
7 8