2N Wireless 3G router 2N EasyRoute_new design - User manual, 1670 v1.06 - Manual (Page 28)

Table of Programmable Parameters 3.2
28
Internet
This Wizard menu helps you configure the UMTS connection to the Internet. The
procedure is similar to that in the ADSL network. Specify the access point and
then verify the user name and password. You do not have to set anything on this
page in most cases. The gateway finds all settings in its database. Click on the
List link. A highlighted line signals that the gateway has found the required
provider data. In that case, close the List window and proceed to the next page.
If you need more settings or no provider data are available in the database, set
the items below as instructed by your UMTS provider.
APN (Access Point Name) identifies the provider’s Internet access code. Enter
the required service access code into the Dial parameter. This telephone number
is determined by the provider. ‘*99#’ is used typically.
Fill in the User and Password items do define the user name and password for
connection to the provider: ‘internet’ in most cases. When you have finished, click
on Apply to proceed to the next page.
Wireless
Use this window to configure WiFi transmission easily. If you do not intend to
enable the wireless network, set nothing and push Apply. If you want to enable
the wireless network, set only the basic parameters here. The other parameters
will be set to default values. Use the SETUP menu to change the default values.
Select/Unselect Enable to activate/deactivate the WiFi transmitter. SSID
(Service Set Identifier) is the WiFi identifier that is sent to users. It is a unique
network identifier in the given space.
System sets security to the 2N® EasyRoute WiFi interface. The available
security levels include WEP, WPA, WPA2 and WPA+WPA2. The WiFi security