2N Wireless 3G router 2N EasyRoute_new design - User manual, 1670 v1.06 - Manual (Page 60)

Table of Programmable Parameters 3.2
60
WAN
Mode
Used for enabling the WAN port function on your gateway. If you enable the WAN
port, LAN4 is converted into WAN. There are three setting options:
 Off – disable the WAN function.
 Static – enable the WAN function. Set the fixed WAN IP address.
Useful especially when you use the cable or WiFi connection and know
the IP address assigned to you.
 PPPoE – enable the WAN function. Enter the login data to your
provider. Used mainly for the ADSL connection where you are assigned
the IP address by the provider after login authentication.
Caution
 Important! The static IP and PPPoE cannot be used at the same time.
Even if both the options are selected and saved in the database, the
option that is programmed is applied.
Static
IP
IP address assigned to your 2N ® EasyRoute WAN port as communicated by your
Internet provider or network administrator.
Subnet
Mask of the network where your 2N ® EasyRoute gateway will be operating as
communicated by your Internet provider or network administrator.
Gateway
Gateway IP address. The IP packets from 2N ® EasyRoute are routed primarily to
this IP address.