2N Wireless 3G router 2N EasyRoute_new design - User manual, 1670 v1.06 - Manual (Page 50)

Table of Programmable Parameters 3.2
50
Protocol
Set the protocol for FAX transmission.
Setting options: UDP/TCP
Port
Set the port to be used for FAX data transmission.
Setting options: 1 - 65535
Default setting: 10004
Bitrate
Set the data flow to be preferred. The data flow set in here need not necessarily
be used. If two opposite devices agree so during the FAX call setup, a lower value
may be selected.
Setting options: 2400 bps
4800 bps
7200 bps
9600 bps
14400 bps
TCF
Define how to perform the training sequence according to the T.38 protocol.
Setting options: Local
Training sequence is performed locally only.
Transferred
Whole training sequence is transmitted in the same
way and under the same conditions as the following
FAX message.
Default setting: Transferred
Buffer size
Set the buffer size for UDP/TCP datagrams.
Default setting: 200 B
Datagram size
Set the maximum UDP/TCP datagram size.
Default setting: 200 B
Error correction
Define how to correct the errors in the FAX messages to be transmitted.
Setting options: Redundancy
2N ® EasyRoute uses the Redundancy Error Correction.
FEC
2N ® EasyRoute uses the Forward Error Correction.