2N Wireless 3G router 2N EasyRoute_new design - User manual, 1670 v1.06 - Manual (Page 45)

Table of Programmable Parameters 3.2
45
Busy tone – Cadence
Set the busy tone cadency, choosing one of the predefined dialtone patterns.
Setting options: Continuous, 320/320/640/640 (Morse A), 330/330,
200/200, 250/250, 375/375, 500/500, 50/50,
1500/3000
Default setting: 200/200
Call tone – Frequency
Set the ringing tone frequency in [Hz]. You can set up to two frequencies for a
dual tone. The first frequency is obligatory, the other is optional.
Setting options: 100–4000 Hz
Default setting: 425 Hz for the first tone, the other is disabled
Call tone – Cadence
Set the ringing tone cadency, choosing one of the predefined dialtone patterns.
Default setting: 1500/3000
Error tone – Frequency
Set the tone frequency in [Hz]. You can set up to two frequencies for a dual tone.
The first frequency is obligatory, the other is optional.
Setting options: 100–4000 Hz
Default setting: 425 Hz for the first tone, the other is disabled
Error tone – Cadence
Set the tone cadency, choosing one of the predefined dialtone patterns.
Default setting: 50/50
SLIC > Advanced ERF
Ring
Set the telephone line ringing voltage modulation, choosing one of the predefined
ringing patterns.
Setting options: 1000/4000, 400/200/400/2000, 1500/3500,
2000/4000
Default setting: 1000/4000
CID
Set this item to enable sending of a calling GSM line identification. The function
can be enabled if you have a FSK/DTMF (ETSI) receiving device on your telephone
line.
Setting options: Disable
2N
® EasyRoute restricts CLI towards the telephone line.
ETSI FSK
2N ® EasyRoute transmits CLI using FSK (Frequency
Shift Keying) to a telephone line.