2N Wireless 3G router 2N EasyRoute_new design - User manual, 1670 v1.06 - Manual (Page 36)

Table of Programmable Parameters 3.2
36
Disconnection notification [1 – 3600s]
A notification SMS is sent when the defined period of time elapses. Errors must
come in a sequence to be considered. This means that the first correct attempt
clears the counter even if the next one is wrong again.
DNS1/DNS2
The IP address of the DNSs used as assigned by the provider upon network login.
Cannot be programmed!
IP
The IP address of the default gateway used as assigned by the provider upon
network login. Cannot be programmed!
FUP
The FUP (Fair User Policy) function is set in this menu. The maximum amount of
data to be transmitted is defined for a certain period of time. The limit is 100 GB.
One selection at least must be ticked off to make this service work. The service is
OFF by default. Exceeding leads to Internet disconnection until the counters are
reset.
Download
Enable that the preset limit should be applied to downloaded data. The second
parameter is for information only and displays the current amount of data
transmitted in the given direction. The third parameter sets the amount of data to
be transmitted. The fourth parameter defines units.
Upload
Enable that the preset limit should be applied to uploaded data. The second
parameter is for information only and displays the current amount of data
transmitted in the given direction. The third parameter sets the amount of data to
be transmitted. The fourth parameter defines units.
Download & Upload
Enable that the preset limit should be applied to downloaded and uploaded data.
The second parameter is for information only and displays the current amount of