2N Wireless 3G router 2N EasyRoute_new design - User manual, 1670 v1.06 - Manual (Page 61)

Table of Programmable Parameters 3.2
61
DNS1/DNS2
IP addresses of the user-preferred DNSs in the Internet.
PPPoE
User
User name used for authorisation as instructed by the Internet provider.
Password
Password used for authorisation as instructed by the Internet provider.
LCP echo interval [1 – 3600s]
Set the LCP echo sending intervals.
LCP echo failure [1 - 10]
Set the count of failed responses to LCP queries after which the PPP demon is
restarted.
DNS1, DNS2, IP
These parameters cannot be programmed. They are for information only and
provide the data that 2N
® EasyRoute received from the ADSL provider after
authorisation.
Note
 LCP echo is a function of the PPP demon, which is responsible for
connection to the provider (UMTS/PPPoE). It sends packets in predefined
intervals and expects responses to them. When the defined count of failed
responses has been achieved, the PPP demon is restarted and tries to
reconnect to the Internet.