2N Wireless 3G router 2N EasyRoute_new design - User manual, 1670 v1.06 - Manual (Page 97)

Troubleshooting 6.2
97
6.2 Troubleshooting
For tips for the solution of other potential problems see faq.2n.cz.

No LED is on after power up.
 Check the power supply.

2N ® EasyRoute is not logging into the GSM network.
 Check the SIM card.
 Check the PIN.
 Check the antenna connection.
 Select a place with a good GSM signal.

The 2N ® EasyRoute Internet connection has not been established.
 Check the setting of the APN assigned to the SIM card by the provider.

No tone can be heard after line off-hook.
 Check the telephone line connection.
 2N ® EasyRoute has not been initialized properly (approx. 10 s after
power up).
 2N ® EasyRoute is not supplied with power.

2N ® EasyRoute is ignoring the user dialling, transmitting the dialtone.
 Select the correct dialling type (DTMF/pulse).
 Adjust the width of the dialling pulses.
 Adjust the delay value between the pulses.

2N ® EasyRoute is not communicating with the PC.
 Check the Ethernet cable connection.

Do you need to set some functions 2N ® EasyRoute?
 Try to find help on HOW TO manuals. Current and new manuals can
always be found on www.2n.cz