2N Wireless 3G router 2N EasyRoute_new design - User manual, 1670 v1.06 - Manual (Page 35)

Table of Programmable Parameters 3.2
35
APN
The APN (Access Point Name) is the provider’s Internet access code. If the item is
not filled in by the user, the gateway uses data from its database.
Dial
Fill in the telephone number of the requested service. This parameter is
determined by the provider.
User
Enter the username for connection to the provider. If you fail to fill in the name,
the gateway uses data from its database.
Password
Enter the password for connection to the provider. If you fail to fill in the
password, the gateway uses data from its database.
Note
 To display the internal APN database, click on the List link. The currently
used data are highlighted in the table. If no table row is highlighted,
2N
® EasyRoute has no data on your provider. In that case, enter the data
manually.
LCP echo interval [0 – 3600 s]
Set the timeout after which the LCP echo should be sent.
LCP echo failures [0 - 10]
Set the count of unsuccessful LCP echo attempts after which the connection error
should be detected. Subsequently, the PPP demon is restarted. The gateway tries
to reconnect to the Internet.
Max connect failures before reset
Set the count of unsuccessful connection attempts after which the system is
restarted.
Note
 LCP echo is a function of the PPP demon, which is responsible for
connection to the provider (UMTS/PPPoE). It sends packets in predefined
intervals and expects responses to them. When the defined count of failed
responses has been achieved, the PP demon is restarted and tries to
reconnect to the Internet.
 As a matter of fact, LCP echo is a self-diagnostic function, which monitors
connection and is able to repair errors if any. Moreover, SMS notification is
associated with this state and so, when an error occurs, a notification SMS
is sent.