2N VoiceBlue Lite - Manual v2.6 - Manual (Page 114)

10.3. Entering licenses to XAPI server
Start the following configuration only if the XAPI sever was
correctly configured and communicates with the gateway. For
configuration of XAPI server see sub. 10.2.
It is needed to enter valid license code to XAPI to activate Voice
Callback centre. License is generated by 2N according to request
service and serial number of gateway.
To find out what serial number gateway has, start terminal in
configuration program or HyperTerminal. Connect to the gateway.
Make sure, that the selected COM port, which you try to open and
connect to the gateway, is not the same as the COM port, which is
opened for communication with XAPI server. Type command:
“ati4”. The gateway answers serial number (SNumber), MAC
address (MacAdr), enabled protocols (Enabled) and limit. Copy
the serial number (M113-aaabbbcccd) and send it to 2N technical
support.
Answer from 2N should contain these keys:
Id=xxxx-yyyy Key=aaaa-bbbb-cccc-dddd
Click “Licenses“ button and after that in License window click
“Set License“.
Fig. 62 - Entering the licence
It is not possible to enter license when the gateway is not
connected to the XAPI server (response is BAD LICENCE!)
104