2N VoiceBlue Lite - Manual v2.6 - Manual (Page 20)

• SIM card insertion – SIM cards are inserted in holders on the
gateway top. The SIM card holder is of the push/pull type,
which means that all you have to do is insert a SIM card and
press the holder gently until it snaps into position (see Subs.
2.7). Secure the SIM card with a latch to avoid incidental
removal.
!CAUTION! If you use PIN-asking SIM cards, first
set an identical PIN code for all SIM cards used in the GSM
gateway, save it into the GSM gateway configuration and only
then insert the SIM cards in the GSM gateway.
• PC connection – the gateway parameters are normally set
using the configuration software available on the CD included
in the delivery. To interconnect your PC with 2N - VoiceBlue
Lite use the USB cable
* * *
or laplink RS 232 cable included in
the delivery.
• Configuration program installations - run the installation
file from the installation CD on a PC connected to the
gateway and install the VoiceBlue Lite configuration software
(refer to Subs. 0).
• Configuration program - run the VoiceBlue Lite program and
set the serial port communication for your PC - gateway
connection. Establish communication between your PC and the
gateway (refer to Subs. ).
• 2N - VoiceBlue Lite configuration - now use the
configuration software to set all necessary gateway parameters
- VoIP parameters basic GSM parameters and tariff
metering/pricing parameters, routing, restrictions, system
parameters, and input and switch properties. Having set the
required parameters, upload the configuration data to the
gateway via a serial link. For more details on the configuration
software see Section 9.
*
Be sure to install the drivers available on the CD included when you use a USB cable.
**of the same type as used for direct PC-PC connection.
10