2N VoiceBlue Lite - Manual v2.6 - Manual (Page 63)

2N - VoiceBlue Lite
7.6. DISA Message
If the DISA function is enabled and a welcome message recorded,
this voice message is replayed to every incoming call whose
number is not included in the CLIP routing table or dynamic CLIP
routing table. After the message is replayed, the gateway waits for
the first DTMF digit for a timeout defined in the GSM incoming
groups – Tout for entering DTMF digits table. Having received the
count of digits defined in GSM incoming groups – Min. digits in
DTMF, the gateway activates the SIP Proxy connection. For more
details on the gateway configuration refer to Subs. 9.5.
It is possible to program the DISA voice message into the gateway
by following ways:
• Record DISA using configuration program (see. sub. 9.4)
• Record DISA using terminal and GSM phone
DISA Message Recording Using Terminal and GSM Phone
Recording of DISA message
Open terminal window (see Subs 11).
• Establish connection with your GSM phone using AT
command: at!sg0=phone_number_of_your_GSM_phone
• Accept incoming call from your GSM gateway by GSM phone.
(CLIP of SIM card plugged in SIM card holder 1)
• Enter AT command at!m0=record in terminal window which
results in recording of DISA message (65 s max)
• To stop recording of DISA message press <ENTER>
• Finish the phone call by hanging up or entering of AT
command at!d
Erasing of DISA Message
To get an information on recorded DISA Message enter AT
command at!m0=status. To erase DISA message enter AT
command at!m0=erase in terminal window.
53