2N VoiceBlue Lite - Manual v2.6 - Manual (Page 78)

Types of communication:
Serial communication - used for GSM gateway
configuration from your PC using a serial or USB cable.
The serial communication mode is suitable for the initial
setup of the gateway and detailed tracing. Configuration
program offers unused COM ports only.
LAN communication – used for GSM gateway configuration
via the Internet or LAN. Be sure to set the IP address of the
gateway you want to communicate with before
configuration. For the IP address setting procedure refer to
Subs. 8.2. Set the Time to wait for response [ms] for
network communication. The default value of this
parameter is 5,000 ms.
Communication LOG:
In this section is possible to set whether and how the
PC - GSM gateway communication should be saved into a
file.
Click on OK to establish connection between your PC and the
GSM gateway.
9.2. Firmware Identification and Upgrade
If you connect the GSM gateway for the first time, please identify
the current firmware version by clicking on “Gateway control ->
Firmware/Licence”. The Firmware/Licence item offers two
sections. The Firmware section (see Fig. 33) helps identify the
current firmware version and upload a new firmware version from
a PC to the gateway. The Licence section enables to unlock the
GSM gateway (refer to Subs. 9.3).
68