2N VoiceBlue Lite - Manual v2.6 - Manual (Page 123)

2N - VoiceBlue Lite
&A view autorouting table <SPACEcontinue>
&R view lcr-routing table <SPACEcontinue>
&TIN view lan + groups + modules inc totals
&TOUT view lan + groups + modules out totals
&G#=atcommand send at command to gsm 1..4
&GALL=cmd cmd for gate 1..4 (RESET,BLOCK,OFF)
&G#=cmd cmd for gate 1..4 (RESET,BLOCK,OFF,ATBAUD)
&S view lan + modules status
&S=info view all modules selected info (by at&S#)
&S# view one module status (1..4)
&QALL view signal quality on all gsm
&Q# view signal quality on gsm 1..4
&L view logfile from recent <SPACEcontinue>
&C view buffer (calls) from recent <SPACEcontinue>
&CR read buffer from the oldest <#erase & continue>
&BSYS=cmd cmd for system (RESET)
&X view conn table/gsm (call states)
&X# view call details/gsm (1..4)
&M0 disable ansi colors
&M1 enable ansi colors
&M9 start matrix
&U view logged users
Extended user commands
&EA view arp table
&EA=cmd cmd for arp table (RESET)
system params:
%S70=iii.iii.iii.iii IP address
%S71=iii.iii.iii.iii IP mask
%S72=iii.iii.iii.iii IP router
%S91=buf,id cdr mode bits (b0=outg, b1=inc, b2=failed, b3=moninfo)
unit id (0=off, 1..255)
%S92=rep report mode (b0=states, b1=tstamp, b2=smp,
b3=lay2, b4=select)
%S98=pin sim pin (max 7 digits)
%S99=dd.mm.yy.w/hh.mm.ss set date/time (w=1..7 day of week)
113