2N VoiceBlue Lite - Manual v2.6 - Manual (Page 124)

%X20=mmdd,mmdd date of hour+1,hour-1 time change (0=off,0101..1231)
%X80=login/pass login name / password (max 15 chars all)
Ethernet parameters:
%E00=xxx protocol (==I00)
%E01=c1,c2,c3 codec list (18,8,0) (0=PCM uLaw, 8=PCM ALaw, 18=G729,
4=G723), 4 and 18 is not possible to use together
%E02=exp,rep,stun expire (sec >= 600), reattempt (sec >= 10) for sip.reg.,stun
timeout
%E03=rtp1,rtp2 rtp ports first (>=1024), last (>=first+10) RTP port, even only !
%E08=bits bit0=reserved
bit1= 1 - send "180 RINGING", 0 - send "183 SESS. PROG"
bit2 = 1 - send "200 OK" instead of 180/183
bit3 = 0 - 486 is sent on rejected call, 1 – 200 and BYE id sent
on rejected call
%E09=day day (0=off,1..31) of clearing stat
%E10=x.x.x.x:port SIP proxy for calls IP-->GSM:port namber used for outtgouing
SIP packets
%E11=x.x.x.x:port SIP proxy for calls IP<--GSM:port number for incoming SIP
packets
%E14=x.x.x.x:port SIP registrar:port number used for registration
%E16=x.x.x.x NAT firewall
%E17=x.x.x.x:port STU IP address:port. For IP = 0.0.0.0 is this function didabled.
Default port = 3478
%E20=blocks,bits codec parameters for PCMA and PCMU, blocks (1..20), bits
(0..255) – 8 control bits, bit0 = 1 support of silence
%E23=blocks,bits codec parameters for G.723, blocks (1..4), bits (0..255) – 8
control bits, bit0 = 1 support of silence,bit1= 0 – high bit rate 6,3
kbps, 1 – low bit rate 5,3 kbps
%E29=blocks,bits codec parameters for G.729, block (1..10), bits (0..255) – 8
control bits, bit0 = 1 support of silence
%E80=name/pass registration name / password (max 31 chars all) for proxy server
%E81=domain domain (max. 31 char)
Group parameters:
%G00=xxxx out.group numbers for g1..g4 (0=off, 1..4=group)
%G01=0,dspo,dspi dsp signal gain level output,input gain (1=-31dB, 32=0dB,
63=+31dB)
%G01=2,atms,afms dsp signal gain dtmf level during test period
%G02=mode,atms,afms tc35 mode (2,4)
114