2N VoiceBlue Lite - Manual v2.6 - Manual (Page 130)

11.7. Records on Operation (LOG)
Type Text Description
POWER [Power on] System switched on
[Power off] System switched off
[Warm boot] Restart of system, unknown cause
[Watchdog] Restart of system by watchdog
[BKPT code] CPU error: break code detected
[Stack error] CPU error: stock integrity failure
[Divided by zero] CPU error: dividing by zero
[RETI code] CPU error: illegal using of instruction reti
[NMI intr] CPU error: wrong interrupt
[VOID intr] CPU error: wrong interrupt
[Upgrade reset] Start of upgrade firmware procedure
[Software reset] Reset by AT commands (at&fres…)
INIT Eeprom Initialisation of eeprom (configuration)
Flash Initialisation of flash memory (firmware)
HW-ERR (##…address of chip, RD…read value/WR…expected value)
Codec ##,RD/WR Error in initialisation of codec on GSM
Duart #####,RD/WR Error in initialisation of serial controller on GSM
SYSERR User stack error! SW error: stock integrity failure
BRDIN #08 TYP STS the board inserted (number of gsm board, type, status)
BRDOUT #08 TYP STS the board disconnected
BRDRES #08 TYP STS Reset the board by AT command
ALL GSM RESET CMD Reset of all GSM modules by AT command
SYSTEM RESET CMD Reset of system by command at&bsys
G2-ERR ATD/ERROR init (g##) Error of layer 2: restart of module g## after rejected command
ATD by GSM network
GSM Cause 150 (g##) Error of layer 2: restart of module g## after cause 150 was
received (call barred by GSM network)
G3-ERR tout sts # (g##) Error of layer 3: timeout in status # on module g##
C4-ERR tout sts # (p##/g##) Error of connecting layer 4: timeout in status # on call between
channel p## and GSM module g##
120