2 configuration by telnet utility, Login to the system – Atop Technology SE5001 Series User Manual
Page 16
User Manual Version 1.6
SE5001 Serial Device Server
Copyright © 2011 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan.
15
->Click on
“Configuration”->”Network” or the “Network” button.
->Enable
“DHCP” on the Network Settings window (Figure 3.3).
->Click
“OK” and SE5001 will restart and get an IP from the DHCP server automatically.
Figure 3.3 SerialManager Auto IP Dialog Window
3.2 Configuration by Telnet Utility
One can use Telnet utility to change configuration settings of SE5001 by following steps：
3.2.1. Login to the System
->Open MS-DOS command prompt window or any other telnet application
->
Telnet to SE5001 using command “telnet IP_address”. (For example ： ”telnet 10.0.50.100” in MS-DOS
command prompt window). After telnet into SE5001, system will prompt for a password, the default password is
blank. (Figure 3.4)
Figure 3.4 Login to the system
Note: Press the default button of SE5001 to reset the password to the default value.
1. After verifying the password, the following terminal screen appears (Figure 3.5).