Atop Technology SE5001 Series - Manual (Page 79)

User Manual Version 1.6
SE5001 Serial Device Server
Copyright © 2011 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan.
78
9. Repeat the process above again for kernel or AP firmware if necessary.
Note: After the upgrading process finishes, SE5001 will program the flash memory and buzzer beeps 6
times then restarts. Normally, it takes around 10 seconds to complete the programming process. If an error
occurs during the programming process, SE5001 will clear the corresponding memory and the system
remains intact of what it was.
B.2 Error Messages
Firmware upgrade may not be successful if errors occur during the process.
Error Cause Message Comments
Illegal Hex file format Hex File Text Error
Hex File Check-Sum Error
Hex File Format Error
Hex File End of Record Error
SE5001 handshaking problem SE5001 ACK Start Address Error
SE5001 ACK Length Error
SE5001 Response Command Error
Configuration file Remote IP not found
Open configuration file failure