Tcp client application: enable rfc 2217, Figure 3.30) – Atop Technology SE5001 Series User Manual
Page 38
User Manual Version 1.6
SE5001 Serial Device Server
Copyright © 2011 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan.
37
is not possible.
Figure 3.30 TCP Client with Virtual COM Enabled
to configure SE5001 in TCP Client mode properly.
Check Enable VirtualCOM for Serial/IP to enabled Virtual COM application in SE5001.
Scroll to the bottom of the page and cli
ck on “Save Configuration” button to save the changes.
Configure Virtual COM in the Operating System. For Windows, refer to
4. Using Virtual COM
. Remember
SE5001
’s IP address and the Local Listening Port here in order to enter this information in Serial/IP
Virtual COM
’s Control Panel later.
3.3.12. TCP Client Application: Enable RFC 2217
The underlying protocol of Virtual COM is based on RFC 2217, the Telnet COM Control Option. Therefore, it is
possible to use RFC 2217 with SE5001 in the TCP Client mode. To do so, refer to section
to enable Virtual
COM, so that SE5001 becomes aware of the commands. Note that there is no need to configure Virtual COM on
the Operating System because Virtual COM ports would not be used.