Atop Technology SE5001 Series - Manual (Page 30)

User Manual Version 1.6
SE5001 Serial Device Server
Copyright © 2011 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan.
29
3.3.2. Networking Setup
Configure IP, SNMP, and alert settings on this page. Please fill in the IP information in the fields under the TCP/IP
header (Figure 3.22). Alternatively, enable DHCP to obtain IP address, gateway and subnet mask from a DHCP
server automatically.
Figure 3.22 IP Information Setup
Enable SNMP and Alert Events by checking “Enable” (Figure 3.23). Fill in SNMP information in the fields under the
SNMP header. Enable different Alert Events to send these events to a SNMP Trap Server.
Cold/Warm Start: Triggers when the device is rebooted from the application level or physical level.
Link Down: Triggers when the TCP connection of the designated COM port is closed
Link Up: Triggers when the TCP connection of the designated COM port is established
Authentication Failure: Triggers when the username/password entered in the Telnet console or the WebUI is
incorrect.