Comelit MT 49804 - Manual (Page 28)

User’s Manual
18
Network Setup
Figure 17 ņ Network menu.
Network
Highlight Network in the Network menu and press the button. The Network setup screen
displays. You will be able to change the Network, LAN, DVRNS and WebGuard settings.
Highlight the box beside Remote Watch – Quality and press the button. You can select the
Quality from: Very High, High, Standard and Basic. Press the button to set the Quality.
NOTE: The higher Quality settings require higher Transfer Speed settings. The transfer
speed you set is the maximum speed. Depending on the network environment, this speed
may not be achieved.
You can limit the network bandwidth settings so that system does not consume too much network
bandwidth. Highlight the box beside Network Bandwidth Limit and press the Up and Down
arrow buttons to set the desired maximum bandwidth from 10Kbps to 100Mbps.
NOTE: When limiting the network bandwidth, the remote watch image on the PC running
RAS or WebGuard might not be displayed properly.
Highlight Enable SSL for Transferring Data and press the button to toggle between On and
Off. When it is On, the security of data except video transmitted for remote monitoring or remote
recording can be enhanced by using the SSL (Secure Sockets Layer) authentication. When using
the SSL function, the DVR cannot be connected with a remote program which does not support
the SSL function.
CAUTION: The remote connection will be disconnected temporarily after changing
the SSL settings.
Figure 18 ņ Network setup screen.
Highlight the first box beside Remote Watch –
Transfer Speed. Press the Up and Down
arrow buttons to set the Transfer Speed from
50Kbps to 100Mbps.
Highlight the second box beside Remote Watch
– Transfer Speed. You can select the unit of
measure for the transfer speed between: bps and
ips. Press the button to set the transfer speed.
NOTE: The local recording speed might be
affected by various network bandwidth
(Transfer Speed) conditions.